Features:
- Provides the simplex S-series VIM2 hardware arrangement for one active interface module.
- Supports controller simulation workflows when used with the compatible DeltaV Mimic environment.
- Loads selectable Ethernet I/O protocol drivers for communication with supported external devices.
The current ordering configuration is SE4026, the DeltaV S-Series Virtual I/O Module 2 documented by Emerson for DeltaV S-Series Virtual I/O Module 2.
SE4026 is used in DeltaV Mimic process simulation using an S-Series VIM2 interface. Its system role and configuration limits must remain aligned with the official specification.
Before commissioning SE4026, verify the installed assembly, project wiring, power, software and environmental conditions that apply to this exact part number.
Availability is subject to Apter Power inventory and sourcing confirmation.
Verified resources for Emerson SE4026:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- DeltaV Mimic process simulation using an S-Series VIM2 interface.
- Ethernet I/O integration with supported Modbus TCP/IP, EtherNet/IP or PROFINET systems.
- Simplex data exchange where one VIM2 and a defined protocol driver meet availability requirements.
- Install the protocol driver selected for the connected system.
- Map datasets and variables to the correct DeltaV control modules.
- Document network addresses, update rates and fail-state behavior.
- Connect SE4026 through the engineered S-Series carrier and Ethernet network.
- Test the external system's data representation before enabling control use.
- Separate simulation operation from live I/O integration in project procedures.
- Confirm VIM2 firmware and driver compatibility with the DeltaV release.
- Back up the driver and module configuration before updates.
- Perform regression tests after firmware or protocol-driver changes.