Features:
- Uses the 8 mm PR 6423 probe family with an 8 m cable, no adapter plug and an open cable end.
- Provides a 2 mm linear measuring range through a 8 m chain without an adapter plug.
- Selects reverse mounting with 8 m total cable and an open cable end.
The current ordering configuration is
PR6423/00R-131, the PR 6423 8 mm Eddy-Current Sensor documented for AMS 6500 Machinery Health.
In the intended system role, the probe forms a calibrated eddy-current chain with an approved converter for non-contact measurement of shaft displacement, vibration or speed.
For selection and commissioning, match the converter, target material, total cable, termination and reverse-mount geometry before installation. Set the initial gap only after the full measuring chain is assembled.
Availability is subject to Apter Power inventory and sourcing confirmation.
Verified resources for Emerson PR6423/00R-131:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Measures radial shaft vibration in a chain configured with an 8 m cable, no adapter plug and an open cable end, for its documented operating duty.
- Tracks axial position changes through the 8 m probe-to-converter path without an adapter plug, through the intended receiving-system interface.
- Provides dynamic gap information through the 8 m lead and an open cable end to the monitoring electronics, in the configured and commissioned installation.
- The sensor and first metre of cable follow the documented high-temperature limits for the probe family, for the documented sensor or probe zone.
- Humidity exposure must not permit condensation inside the cable termination enclosure, at every exposed connection point.
- Temperature at the converter remains governed by the converter rather than the probe rating, throughout steady-state machinery operation.
- The installed probe provides IP66 protection under the stated mounting conditions, under the stated mounting or enclosure conditions.
- The open cable end requires a protected, correctly sealed termination point, throughout the commissioned installation.
- Cable materials must be checked against oil, chemicals and local atmosphere, as part of the site's environmental assessment.
- Reverse mounting requires the machine bracket to suit the probe geometry, so the installed interface matches the documented arrangement.
- The eight-metre lead must be routed without crushing, sharp bends or unapproved splices, without changing the defined hardware or signal path.
- Final gap adjustment is performed with the matched converter energized and verified, before the channel or assembly is accepted for service.