Features:
- Exact assembly identity: the outer label carries 5X00225G01 and SUB. 09.
- Four-position structure: the front shows four visible module positions.
- Separated interfaces: central power labels are distinct from side local-I/O labels.
The molded Ovation base presents four visible module positions, split into left and right pairs around the central connector column.
J1 Power and J2 Power Monitor are stacked in the middle; J3 Local I/O L9–L16 and J4 Local I/O L3–L8 remain at opposite edges.
A complete receiving match uses the outer controller-base label and the front connector layout together, while the internal MOORE mark remains tied to the board on which it appears.
For Emerson 5X00225G01 Controller Base Assembly quotation, documentation, and procurement support, Apter Power can review the complete label, SUB. 09 marking, and visible interface layout.
Emerson 5X00225G01 Controller Base Assembly Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Assembly designation: The outer label reads CTLR BASE ASSY.
- Complete order code: The controller-base identity is 5X00225G01.
- Sub-revision: The supplied reference unit carries SUB. 09.
- Platform marking: Ovation branding is molded into the base.
- Central power: The upper center connection is labeled Power J1.
- Power monitor: The lower center connection is labeled Power Monitor J2.
- Left local I/O: J3 is labeled Local I/O L9–L16.
- Right local I/O: J4 is labeled Local I/O L3–L8.
- Product-level label: The outer CTLR BASE ASSY label identifies the complete base.
- Revision field: SUB. 09 remains separate from the Product Model.
- Internal board mark: MOORE 15853-31-1 appears on a component inside the base.
- Receiving boundary: The outer assembly code, not the internal board mark, controls the whole-base identity.
- Controller-station assembly: Provides the labeled base for the shown processor and interface-module positions.
- Incoming inspection: Lets receiving staff match the assembly code, SUB. 09, and front-interface layout.
- Installed-base maintenance: Keeps the complete controller-base object separate from its internal or plug-in components.