Features:
- Four independent relay switching points support separate temperature control decisions.
- A four-digit red LED display provides local temperature and status indication.
- A selectable analog output supports integration with PLC and monitoring systems.
The current configuration is the ETS 1701 display version with a 0 to 100 °C measuring range and standard modification code 000.
The electronic controller is intended to process a PT 100 signal and operate relay-based heating, cooling, or alarm functions in hydraulic equipment.
Before installation, verify the separate probe type, terminal arrangement, relay grouping, supply voltage, and required analog signal format.
Availability: Configuration and condition should be confirmed before ordering.
HYDAC ETS 1701-100-000 Manuals, Datasheets, Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Hydraulic heating-process control for maintaining the required fluid temperature during machine operation.
- Hydraulic cooling-process control for supervising temperature reduction and protecting hydraulic equipment.
- Temperature monitoring through PLC-based systems for reliable process feedback and control decisions.
- The controller stores the maximum temperature reached since power-up or the last reset.
- Display filtering can be selected to provide slower, medium, or faster indication behavior.
- Reverse-polarity, overvoltage, override, and short-circuit protection are provided.
- Relay switch-on and switch-off delays can be configured independently within the controller.
- Each relay can be set for normally open or normally closed switching direction.
- Programming disable prevents unauthorized changes after commissioning.
- The separate temperature probe connects through the specified five-pole Binder interface.
- The 14-pole plug-in terminal block provides the electrical connection for supply and outputs.
- The analog output can be connected to a PLC or supervisory monitoring input.