Fast Quote
Active / Available from OEM
Apter Power can provide Honeywell R40H/20HH-10S-XBM3 for verified MasterLogic 50 requirements, with quotation, sourcing support and delivery planning for the requested quantity.
R40H/20HH-10S-XBM3 adds smart link cable assembly, 20 x 2 to 40 positions, 1.0 m to a verified Honeywell control configuration.
Select connected hardware, field interface and project parameters as one engineered assembly.
Use the exact model and revision when planning a replacement or spare.
Apter Power can provide Honeywell R40H/20HH-10S-XBM3 with quotation and sourcing support.
Verified resources for Honeywell R40H/20HH-10S-XBM3:
Confirm both endpoints before fitting R40H/20HH-10S-XBM3.
Route and secure the cable or terminal accessory without stress or pin misalignment.
R40H/20HH-10S-XBM3 should be selected by exact function, terminals and supported controller or adapter.
A similar enclosure or connector does not establish interchangeability.
Commission R40H/20HH-10S-XBM3 against the approved signal, load or communication design.
Resolve diagnostic, scaling and field-response discrepancies before automatic operation.
Inspect R40H/20HH-10S-XBM3 and its mating hardware before energization.
Record the nameplate, revision, settings and final test results for future maintenance.
R40H/20HH-10S-XBM3 is a Honeywell masterlogic 50 accessory for the MasterLogic 50 control platform. Its documented function is smart link cable assembly, 20 x 2 to 40 positions, 1.0 m, allowing the controller architecture to add the required field, communication or service capability while retaining a consistent engineering environment.
The R40H/20HH-10S-XBM3 provides smart link cable assembly, 20 x 2 to 40 positions, 1.0 m. Confirm connector keying, connected endpoints, cable routing and terminal mapping because mechanical fit alone does not prove electrical compatibility.
Before installing or replacing the R40H/20HH-10S-XBM3, verify the complete nameplate, hardware revision, terminal diagram, connected module or cable, supply and field-circuit limits, firmware support and retained control project. Commissioning should include visual inspection, point or link diagnostics, controlled functional testing and documentation of the final installed configuration.





