Features:
- Three 20 A outputs: the label defines a high-current 3x64 motor group.
- 14/17 kW channel points: the output power marking differs from the lower KSP classes.
- DC-link input: the servo pack is supplied from the KR C4 intermediate circuit.
The article concentrates three higher-current axis amplifiers within one KSP assembly.
Its 20 A output rating is a selection boundary, not an invitation to replace lower-current configurations without approval.
Exact identification and disciplined cable mapping are essential because all three motor paths share the same module housing.
Apter Power can review 00-198-269 3x64 label identity, high-current configuration, condition, and quotation details.
KUKA 00-198-269 KSP 600-3x64 Servo Pack Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Three equal AC motor outputs are each marked at 20 A.
- The channels cover 0–400/480 V and 0–500 Hz within the documented output range.
- Each output group carries the 14/17 kW label points associated with the 3x64 class.
- The KSP draws from a 565/675 V DC intermediate circuit rated at 25 A.
- Three motor paths are integrated in the same chassis and remain separately assigned in the cabinet.
- The higher current class must agree with the connected axes and controller design.
- Article and hardware labels should be photographed before installation and retained with the service record.
- Cable identity, connector seating, feedback status, and safety-state clearance precede motion testing.
- Each axis is tested individually before coordinated robot movement is restored.
- Supply a documented high-current three-axis motor group inside a KR C4 drive cabinet.
- Restore servo control where the installed bill of materials specifies the 3x64 output class.
- Support controlled robot recommissioning with three individually verified axis paths.