- Use the 36 A maximum-current class with 21.3 A continuous output at 4 kHz for axis selection
- Apply the verified 15 A continuous-current limit when 8 kHz switching is required
- Confirm the DC-bus source, motor cable and separate control section instead of treating W0036 as a complete drive
HMS01.1N-W0036-A-07-NNNN is a Bosch Rexroth IndraDrive M HMS01 single-axis inverter power section with a 36 A maximum output.
Its 254–750 V DC-bus input supplies a three-phase motor output, with continuous current limited to 21.3 A at 4 kHz and 15 A at 8 kHz.
Before commissioning, inspect the terminals and cooling passages, then verify the DC-bus supply, control section, firmware, motor and encoder wiring, and saved axis parameters.
Availability, condition, price, and shipping time for HMS01.1N-W0036-A-07-NNNN are confirmed during quotation.
Bosch Rexroth HMS01.1N-W0036-A-07-NNNN Single-Axis Inverter Power Section Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Do not treat the shared W0020/W0036 enclosure as electrical equivalence
- Match the control section, firmware, motor and feedback system
- Confirm the common-DC-bus supply and protection capacity
- Verify motor insulation, cable length and switching frequency
- Restore motor data, feedback polarity and brake timing
- Check low-speed current reduction against the load profile
- Inspect type plates, terminals, touch guard and fan path
- Reject evidence of heat damage or stressed power connections
- Complete staged no-load and loaded acceptance tests
- Single-axis operation in a Rexroth IndraDrive M HMS01 system
- Three-phase asynchronous motor operation
- Three-phase synchronous motor operation