Features:
- IGB7 module: Siemens identifies the exact item as an inverter control module.
- Device range: It is listed for 500–690 V AC and 675–930 V DC equipment.
- Successor path: Siemens identifies 6SE7033-5GJ84-1JC2 as the successor.
The 354 A reference belongs to the supported device class, not a stand-alone board output rating.
The official packaging data is 70 × 38 × 5.5 cm with a net weight of 0.84 kg.
A successor listing does not remove the need to compare the installed drive, hardware revision and connectors.
Apter Power can quote 6SE7033-5GJ84-1JC0 and support successor-fit review.
Siemens 6SE7033-5GJ84-1JC0 Manuals, Datasheets, Links
- AC host boundary: Use within the documented 500–690 V three-phase SIMOVERT device class; the module is not a stand-alone AC drive.
- DC host boundary: The corresponding 675–930 V DC class identifies the supported converter environment, not a board supply input.
- Current-class meaning: The 354 A figure belongs to the host drive class and should not be applied as an independent module output rating.
- Lifecycle planning: Siemens lists 6SE7033-5GJ84-1JC2 as the official successor, while the installed drive record remains necessary for migration planning.
- Connector alignment: The module must align with the assigned SIMOVERT slot and existing interface connectors without forced insertion.
- Hardware pairing: Installed control hardware and the saved drive configuration should be treated as one validated set.
- Harness orientation: Original plug positions, cable routing and shield connections should be recorded before the module is removed.
- Diagnostic context: Module indications should be assessed together with the host drive fault history and control state.
- Pre-power inspection: Confirm full seating, secure connectors and the absence of damaged contacts before energizing the converter.
- Parameter recovery: Load only a verified parameter archive that belongs to the installed SIMOVERT hardware configuration.
- Initial energization: Review module and drive diagnostics before the power stage is enabled.
- Controlled test: Compare command, feedback and fault response during a controlled machine test before normal operation resumes.
- Legacy drive service: Supports existing SIMOVERT MASTERDRIVES installations that use the documented IGB7 control architecture.
- AC converter cabinets: Applies to the specified 500–690 V three-phase host-drive class in maintained industrial systems.
- DC converter systems: Applies to the documented 675–930 V DC host class where this module code is installed.
- Control-panel restoration: Useful when restoring the original inverter-control function while retaining the validated drive configuration.