Features:
- SIMATIC S7-400 CPU 416F-2 for standard and fail-safe automation
- 8 MB integrated work memory divided into 4 MB code and 4 MB data
- MPI/PROFIBUS DP plus a second PROFIBUS DP interface
6ES7416-2FP07-0AB0 identifies the exact Siemens ordering configuration shown in the official product record.
Confirm the project, interfaces, mounting and power requirements before installation.
The Siemens 6ES7416-2FP07-0AB0 Fail-safe CPU is listed as an active product by Siemens. Apter Power can provide quotations, official technical documents and sourcing support.
Siemens 6ES7416-2FP07-0AB0 Fail-safe CPU Manuals, Datasheets, Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Siemens 6ES7416-2FP07-0AB0 Fail-safe CPU Specs
General
- ManufacturerSiemens
- Model6ES7416-2FP07-0AB0
- ConditionNew Original ready stock
- Product FamilySIMATIC S7-400 CPU 416F
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Processing data:
- 8 MB integrated work memory: 4 MB code and 4 MB data
- 12.5 ns typical processing time for bit, word and fixed-point operations
- 25 ns typical processing time for floating-point operations
Use the official S7-400 project data when configuring memory and execution requirements.
Communication:
- MPI / PROFIBUS DP interface with transmission rates up to 12 Mbit/s
- Second interface for PROFIBUS DP communication
- Interfaces support integration into SIMATIC S7-400 automation architectures
Match addresses, bus parameters and project configuration before commissioning.
Engineering notes:
- CPU 416F-2 is intended for standard and fail-safe automation tasks
- Safety functions require approved SIMATIC configuration and engineering procedures
- Rack, firmware and interface compatibility must be checked for the target system
Commission safety-related functions only with the applicable Siemens documentation.