Features:
- Runs the rack controller and communications gateway functions for an ABE04x VM600 system.
- Stores the rack configuration and uses QNX 6.4.1 with 512 MB CompactFlash.
- Provides one integral Ethernet interface and one configurable serial interface in the C=1 hardware option.
The current ordering identity combines CPUM PNR 200-595-074-122 with CPU module identifier 200-595-100-014 for the earlier VM600 CPUM hardware generation.
It coordinates rack configuration, event handling and Modbus data exchange while the installed monitoring cards continue their dedicated measurement and protection functions.
Before replacement, verify the ABE04x rack, IOCN pairing, firmware, interface routing and saved configuration because later PFM-541I carrier boards are not interchangeable.
Availability is subject to Apter Power inventory and sourcing confirmation.
Verified resources for Vibro-Meter 200-595-100-014:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Integrates multiple VM600 monitoring cards in centralized turbine, generator, compressor and pump protection installations.
- Shares selected rack measurements and operating status with plant control or engineering systems through Modbus communications.
- Supports service replacement in established ABE04x racks that retain the earlier CPUM hardware and project files.
- The C=1 hardware option provides one integral 10/100BASE-TX Ethernet interface and one serial interface.
- Modbus TCP and Modbus RTU exchange selected rack data with DCS, PLC or engineering systems.
- PROFIBUS requires an additional VM600 Molex/VME interface, while firmware 074 does not provide PROFINET support.
- VM600 MPSx and CPUM Configurator manage rack settings, network parameters and configuration files.
- The firmware-074 generation stores its operating image and project files on 512 MB CompactFlash under QNX 6.4.1.
- Export the existing configuration and record the serial routing before replacing or commissioning the controller.
- The 074 firmware generation runs QNX 6.4.1 and supports the documented Modbus communication functions.
- PROFINET requires CPUM firmware 081 or later and must not be assigned to this firmware-074 configuration.
- Firmware and hardware identifiers must remain paired because 075-or-earlier and 076-or-later carrier generations are not interchangeable.