Features:
- The stainless-housing intrinsic-safety configuration uses the 10 to 200 kPa (1.45 to 29 psi) capsule, direct-mount pressure connection and 1/2 NPT female, two entries with 316 SST blind plug.
- The stainless-housing intrinsic-safety configuration provides 4–20 mA DC with digital communication through HART 5/HART 7 protocol, with digital indicator.
- The stainless-housing intrinsic-safety configuration combines 1/2 NPT female process connection, 316L SST process connector with Hastelloy C-276 diaphragm and 316 SST 2-inch pipe bracket.
The supplied EJA530E-JAS4N-02CDL/NF2 variant is distinguished by A capsule code, stainless amplifier housing and NEPSI intrinsic-safety approval.
It converts gauge pressure into a control-system signal and supports configuration or diagnostic access through HART 5/HART 7 protocol.
Match stainless housing, NF2 entity parameters or approval temperature limits to the existing assembly before wiring, pressurization or actuator movement.
Availability is subject to Apter Power inventory and sourcing confirmation.
Verified resources for Yokogawa EJA530E-JAS4N-02CDL/NF2:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- The stainless-housing intrinsic-safety configuration measures liquid, gas or steam line pressure through a direct process-mounted connection.
- The stainless-housing intrinsic-safety configuration supports pump, compressor, vessel or header pressure monitoring in an engineered control loop.
- The stainless-housing intrinsic-safety configuration provides a primary pressure variable and diagnostic status for process control or asset monitoring.
- Configuration tools must recognize the EJA530E DPharp EJA Series device description and the selected HART 5/HART 7 protocol signal type.
- The analog loop remains available to a compatible control input while digital variables use the same pair of conductors.
- Host alarm handling must be mapped to the transmitter diagnostics without overriding the plant trip philosophy.
- The enclosure provides IP66/IP67, Type 4X protection only with all covers and cable-entry hardware fully secured.
- Pressure containment depends on the specified 1/2 NPT female process connection and the chemical suitability of 316L SST process connector with Hastelloy C-276 diaphragm.
- The /NF2 option specifies NEPSI Ex ia IIC T4 Ga intrinsic-safety approval for HART/BRAIN protocol types.
- The two-wire 4–20 mA DC with digital communication loop combines power and measurement transmission while retaining HART 5/HART 7 protocol parameter access.
- Remote setup and self-diagnostics reduce unnecessary enclosure opening during routine service activities.
- The selected digital indicator supports local confirmation without adding a separate panel instrument where applicable.