Features:
- The NF2-approved M-capsule configuration with stainless bolting uses the 1 to 100 kPa (4 to 400 inH2O) capsule, horizontal piping with left-side high pressure and 1/2 NPT female, two entries with blind plug.
- The NF2-approved M-capsule configuration with stainless bolting provides 4–20 mA DC with digital communication through HART 5/HART 7 protocol, with digital indicator.
- The NF2-approved M-capsule configuration with stainless bolting combines 1/2 NPT female process connectors, S-code wetted assembly with Hastelloy C-276 diaphragm and 304 SST flat 2-inch pipe bracket.
For EJA110E-JMS4G-917DB/NF2, the order code combines NF2 intrinsic-safety entity values and M-capsule range as one matched configuration.
It measures differential and static pressure for engineered flow, level, density or equipment-monitoring duties, with remote access through HART 5/HART 7 protocol.
Installation approval should include a documented check of approval suffix, bolt material or pressure orientation and the connected system.
Availability is subject to Apter Power inventory and sourcing confirmation.
Verified resources for Yokogawa EJA110E-JMS4G-917DB/NF2:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- The NF2-approved M-capsule configuration with stainless bolting measures differential pressure across a primary flow element, filter, heat exchanger or vessel connection.
- The NF2-approved M-capsule configuration with stainless bolting supports inferred flow, level or density calculations when the impulse-piping and manifold design are validated.
- The NF2-approved M-capsule configuration with stainless bolting provides differential and static-pressure information for process control, protection or condition monitoring.
- The transmitter family is specified for 0 to 100% relative humidity when covers and cable entries are correctly sealed.
- Condensation control depends on maintaining the IP66/IP67, Type 4X enclosure and using an approved conduit sealing method.
- The 1/2 NPT female, two entries with blind plug entry must prevent moisture migration into the terminal compartment during outdoor operation.
- The documented 4–20 mA DC with digital communication output supplies the primary process variable to an analog control or safety input.
- Damping and output characterization can be configured without changing the physical 1 to 100 kPa (4 to 400 inH2O) capsule selection.
- Failure-current behavior must be coordinated with the receiving controller's upscale or downscale alarm strategy.
- Back up range, damping, output mode, alarm direction and tag data before exchanging the transmitter electronics.
- Any host update must retain support for HART 5/HART 7 protocol and the selected diagnostic variables used by the control system.
- After restoration, compare the downloaded configuration with the physical 1 to 100 kPa (4 to 400 inH2O) capsule and 1/2 NPT female process connections.