Features:
- Two analog current-output channels in a POINT I/O module.
- 24 V DC supply with the K-suffix conformal-coated construction.
- Rockwell product record lists an operating range of -20 to 55 °C.
1734-OE2CK sends two configured current-output signals to field devices from a POINT I/O station.
The coating designation of 1734-OE2CK differentiates it from the uncoated OE2C, while the current-output function differentiates it from OE2V voltage versions.
The published temperature range is a module specification; the complete enclosure, terminal base and field loop still require system-level review.
Apter Power can help review documentation, quotation and sourcing for the Allen-Bradley 1734-OE2CK Conformal-Coated Analog Output Module.
Allen-Bradley 1734-OE2CK Conformal-Coated Analog Output Module Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Use 1734-OE2CK when two analog current outputs are required; the OE2VK variant is a voltage-output module.
- Confirm that the K suffix is specified for the conformal-coated module before substituting an uncoated OE2C.
- Record the installed module series and controller channel ranges before ordering a replacement.
- Supply the 1734-OE2CK POINT I/O assembly according to the 24 V DC installation requirements.
- Compare the mounting base, removable terminal block and channel wiring with the Rockwell 1734-IN002 drawing.
- Keep current-loop polarity and the connected load recorded separately for each of the two outputs.
- Verify channel 0 and channel 1 wiring and configured current ranges before enabling 1734-OE2CK outputs.
- Check field-device response to a controlled test signal on each loop after replacement.
- If the analog value or fault status differs from the controller project, stop and inspect the terminal-base and load connection.
- Two-channel current-loop control from a conformal-coated POINT I/O station.
- Replacement of an installed 1734-OE2CK in a 24 V DC distributed I/O assembly.
- Analog current output to two separately wired field devices when the programmed ranges and loads are verified.