- Adds one CAN interface to an X20 station
- Provides integrated CAN termination and galvanic isolation
- Supports serial connection of complex remote devices
X20CS1070 is a B&R can bus communication module designed for the X20 System.
The module adds serial CAN communication to an X20 station so complex CAN devices can be connected through the controller application.
Before installation or replacement, verify the complete material number, CAN protocol and application requirements, bit rate, node addressing, X20TB12 pinout, termination state, cable length and topology, X20BM11 or X20BM15, Automation Studio configuration, and bus-load calculation.
Availability, condition, price, and shipping time for X20CS1070 are confirmed during quotation.
B&R X20CS1070 CAN Bus Communication Module Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Bit rate and node addresses are defined by the application
- Maximum distance depends on bit rate and correct CAN topology
- The integrated terminator should be enabled only at a physical segment end
- The module may be positioned anywhere on the remote backplane
- The Automation Studio project must match the installed slot
- Application software defines the required CAN protocol handling
- Run and error indicators report module state
- Data-transfer indicators support commissioning
- Termination status is visible for physical-layer checks
- Connecting complex CAN devices to an X20 controller
- Adding an application-managed CAN segment to a remote X20 station
- Maintaining isolated CAN communication in modular machinery