Features:
- Stainless-steel tubing protects the probe cable
- 3.8-inch case with a 1.0-meter total length
- 1/2-inch NPT exit and miniature ClickLoc connector
The 146056 family adds stainless-steel tubing to the ceramic capped probe lead. This build uses a 3.8-inch overall case and extends to 1.0 meter in total.
A 1/2-inch NPT exit provides the tubing interface, while the ClickLoc coaxial connector terminates the standard cable. The probe tip and stainless-steel case materials remain those documented for the 3300 ceramic capped design.
Plan the tubing run before installation and verify the NPT orientation, bend path, case clearance, system electrical length, and approval conditions.
Availability for this tubing-protected probe assembly is subject to Apter Power inventory and sourcing confirmation.
Bently Nevada 146056-38-10-02-02-05 3300 Ceramic Capped Proximity Probe with Stainless Steel Tubing Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Bently Nevada 146056-38-10-02-02-05 3300 Ceramic Capped Proximity Probe with Stainless Steel Tubing Specs
General
- ManufacturerBently Nevada
- Model146056-38-10-02-02-05
- ConditionNew Original ready stock
- Product Family3300 Ceramic Capped Probe
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Protected Cable Path
- Protection: Stainless-steel tubing surrounds the outgoing probe cable.
- Exit fitting: Option 02 specifies a 1/2-inch NPT fitting.
- Routing: The tubing path should avoid interference and excessive bending.
- Sealing: The fitting arrangement must follow the site installation plan.
Electrical Interface
- Connector type: Option 02 selects a miniature ClickLoc coaxial connector.
- Cable type: The connector is supplied with standard coaxial cable.
- Cable impedance: The documented lead is 75 ohms.
- System interface: Match the lead to the correct extension cable and Proximitor Sensor.
Fit and Approval Review
- Case envelope: Allow for the 3.8-inch probe case.
- Thread: Provide a 3/8-24 UNF mounting point.
- Electrical match: Confirm total system length before commissioning.
- Hazardous area: Use the applicable approval drawing and temperature class.