Features:
- Seats the regulator cards in their assigned rack positions.
- Distributes control power through the regulator assembly.
- Routes signals between installed control and interface boards.
Within a simplex EX2100 regulator-control rack, IS200ERBPG1A provides the backplane position used by the ACLE module and its surrounding regulator hardware.
The keyed connectors on IS200ERBPG1A preserve assigned board locations while carrying signal and control-power paths across the regulator assembly.
Because IS200ERBPG1A is the common passive interconnect, a damaged mating contact can disturb more than one regulator-board function.
For regulator-backplane purchasing and available manufacturer literature, Apter Power supports the General Electric IS200ERBPG1A Exciter Regulator Backplane used in GE excitation-control service.
General Electric IS200ERBPG1A Exciter Regulator Backplane Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Card-Slot Layout for IS200ERBPG1A
- Source: Preserves fixed connector relationships within the rack.
- Processing: Supports field cabling through backplane-mounted interfaces.
- Destination: Keeps controller wiring organized as a replaceable assembly.
- Verification: Belongs to the EX2100 regulator hardware platform.
Backplane Signal Paths for IS200ERBPG1A
- Purpose: Keeps controller wiring organized as a replaceable assembly.
- Connection: Belongs to the EX2100 regulator hardware platform.
- Behavior: Uses keyed board positions to limit incorrect insertion.
- Boundary: Requires inspection of mating connectors before reuse.
Power & Grounding for IS200ERBPG1A
- Input path: Uses keyed board positions to limit incorrect insertion.
- Output path: Requires inspection of mating connectors before reuse.
- System effect: Depends on cabinet cooling and grounding provisions.
- Check: Carries no standalone software configuration.
Replacement Inspection for IS200ERBPG1A
- Placement: Depends on cabinet cooling and grounding provisions.
- Interface: Carries no standalone software configuration.
- Operation: Must be matched to the existing regulator chassis layout.
- Service point: Seats the regulator cards in their assigned rack positions.