Features:
- Sixteen 115 VAC inputs are organized as two groups of eight
- Input thresholds are selectable from 25% to 85% for each group
- Open-wire and short-circuit diagnostics assist field troubleshooting
The IC660BBD110 ordering code selects a sixteen-input AC block rather than a mixed I/O or relay-output device.
Two eight-point groups receive 115 VAC field states, apply configured thresholds and filtering, and report the resulting input data and diagnostics on the Genius bus.
Application setup should account for proximity-switch leakage, group thresholds, open-wire test behavior, field conductor size, and the assigned PLC references.
The General Electric IC660BBD110 115 VAC 16-Circuit Input Block is available for quotation, official documentation, configuration review, and system-matching support from Apter Power.
General Electric IC660BBD110 115 VAC 16-Circuit Input Block Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
General Electric IC660BBD110 115 VAC 16-Circuit Input Block Specs
General
- ManufacturerGeneral Electric
- ModelIC660BBD110
- ConditionNew Original ready stock
- Product FamilyGE Genius I/O
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Two-bank organization
- Group layout: Sixteen inputs are divided into two groups of eight.
- Field source: Apply 93 to 132 VAC at 47 to 63 Hz.
- Sensor types: Use contacts or compatible two- and three-wire proximity devices.
- Reference map: Assign the sixteen input states to the intended controller references.
Signal qualification
- On threshold: Choose the required percentage independently for each group.
- Off threshold: Coordinate the setting with sensor leakage and line conditions.
- Filter time: Select 10 to 100 ms to balance speed and noise rejection.
- Processing: Include the block's input time in the total control response.
Diagnostic preparation
- Open-wire test: Confirm the connected circuit supports the configured diagnostic.
- Short-circuit test: Interpret the indication against the field schematic.
- Terminal conductors: Follow the allowed wire sizes for power and input terminals.
- Commissioning: Record group settings before placing the block in service.