- Supplies the VME control rack from a 125 VDC cabinet source
- Distributes five local and one remote +28 V PSA output
- Front switch and green/yellow/red LEDs support isolation, reset and fault review
IS2020RKPSG3A mounts on the right side of a Mark VI VME control or interface rack and converts the station DC source into the regulated rails used by rack electronics and connected PSA loads.
The G3 execution provides a status-ID output, one remote +28 V PSA branch and five additional +28 V PSA outputs while omitting the PS335 flame-detector feed associated with other RKPS groups.
Its 7.16 kg mass and heat-sink construction require secure bracket support; connector transfer and fault reset must be performed with the source isolated and stored energy discharged.
Availability, condition, price, and shipping time for IS2020RKPSG3A are confirmed during quotation.
General Electric IS2020RKPSG3A Mark VI VME Rack Power Supply Module Product Family, Support, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- PSA and PSB harnesses deliver regulated rails into the VME rack
- Five local +28 V branches support assigned rack loads
- One remote +28 V branch supplies the documented external path
- Yellow confirms input power at the supply
- Green reports normal enabled output and closes the status path
- Red identifies a fault that must be corrected before reset
- The finned module attaches to the rack's right-side bracket
- Bottom connectors are removed only after source isolation
- The heavy assembly is supported independently during withdrawal
- Mark VI VME control-rack power conversion
- Turbine I/O interface rack supply
- Redundant control-cabinet PSA distribution where G3 is specified