Features:
- IC600PM502 powers a standard Series Six I/O rack.
- The regulated +5 VDC rail supplies up to 6.1 A.
- Jumper selection supports both 115 and 230 VAC sources.
The supply provides 100 load units for the modules installed in a standard-capacity I/O rack.
A front circuit breaker controls logic power, while the POWER OK indicator confirms that the DC output is in range.
Card-guide mounting, two quarter-turn fasteners, and a covered terminal board support rack installation and service.
For a quotation on the General Electric IC600PM502 Standard I/O Rack Power Supply, Apter Power can also provide relevant GE manuals or product documentation.
General Electric IC600PM502 Standard I/O Rack Power Supply Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Selecting the AC input source
- Low range: Operate from 95 to 130 VAC.
- High range: Operate from 190 to 260 VAC.
- Frequency: Both ranges accept 47 to 63 Hz.
- Jumper: Select 115 or 230 VAC before energizing the rack.
Supplying the standard I/O rack
- Rail: IC600PM502 provides one regulated +5 VDC output.
- Capacity: Maximum output current is 6.1 A.
- Load budget: The standard rack supports 100 load units.
- Quality: Output tolerance is ±2%, with 2% peak-to-peak maximum ripple.
Installing the I/O power supply
- Position: Mount the supply at the far right of the rack.
- Guides: Slide the assembly along the rack card guides.
- Retention: Secure both quarter-turn fasteners.
- Terminal safety: Refit the protective cover after wiring the three-wire AC source.
Reading power and protection status
- POWER OK: The LED lights when the DC output reaches its specified range.
- Overvoltage: The +5 VDC rail is protected at 6.2 VDC ±0.5 V.
- Overcurrent: Output protection is built into the supply.
- Troubleshooting: An unlit indicator requires input, loading, and output-voltage checks.