Features:
- Three matched 17 A paths: the outputs share one documented electrical class.
- 3x40 drive role: the servo pack serves a medium-current axis group.
- 3B hardware evidence: the supplied KUKA label records the photographed revision.
This servo pack regulates three motor paths from the KR C4 intermediate DC supply.
The 17 A rating creates its most useful selection boundary within the three-channel KSP family.
Diagnosis should compare the common module state with each individual axis circuit before a replacement decision is made.
Apter Power can review 00-198-268 3x40 current class, label traceability, condition, and procurement requirements.
KUKA 00-198-268 KSP 600-3x40 Servo Pack Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Each of the three AC outputs is marked at 17 A.
- All channels share the stated 0–400/480 V and 0–500 Hz range.
- The label associates 12/14 kW points with the motor-output section.
- The KSP converts intermediate-circuit power into controlled three-phase motor outputs.
- Three output paths allow one module to serve a documented manipulator axis group.
- The controller configuration and feedback system remain part of the complete closed-loop drive function.
- A common DC-link or module fault can affect more than one channel simultaneously.
- A single-axis symptom should also be traced through its cable, motor, feedback, and mechanical load.
- Article 00198268, 3x40 marking, 3B hardware evidence, and connector map should agree before exchange.
- Operate a documented three-axis KR C4 drive group requiring the 17 A KSP output class.
- Support robot-cell maintenance where one failed axis must be separated from a common servo-pack issue.
- Hold an article-controlled spare for installed cabinets whose records specify KSP 600-3x40.