Features:
- The BRAIN-output DIN-thread configuration uses the 0.5 to 10 MPa (72.5 to 1450 psi) capsule, direct-mount pressure connection and G1/2 female, one entry without blind plug.
- The BRAIN-output DIN-thread configuration provides 4–20 mA DC with digital communication through BRAIN protocol, with no integral indicator.
- The BRAIN-output DIN-thread configuration combines M20×1.5 DIN 16288 male process connection, 316L SST process connector with Hastelloy C-276 diaphragm and No mounting bracket.
Use the full EJA530E-DCS9N-010NN code when matching the configuration defined by BRAIN output, C capsule, M20 male process connection and no display or bracket.
It converts gauge pressure into a control-system signal and supports configuration or diagnostic access through BRAIN protocol.
The replacement review must resolve BRAIN host compatibility, M20 process thread or absence of indicator before the equipment is returned to service.
Availability is subject to Apter Power inventory and sourcing confirmation.
Verified resources for Yokogawa EJA530E-DCS9N-010NN:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- The BRAIN-output DIN-thread configuration measures liquid, gas or steam line pressure through a direct process-mounted connection.
- The BRAIN-output DIN-thread configuration supports pump, compressor, vessel or header pressure monitoring in an engineered control loop.
- The BRAIN-output DIN-thread configuration provides a primary pressure variable and diagnostic status for process control or asset monitoring.
- The selected capsule supports a calibrated span of 0.5 to 10 MPa (72.5 to 1450 psi) within a configurable range of -0.1 to 10 MPa (-14.5 to 1450 psi).
- Linear or square-root output, damping, engineering units and alarm direction are set through the supported interface.
- The absence of an integral indicator means local range-setting access is unavailable at the installed instrument.
- The suffix defines direct-mount pressure connection, so impulse piping must preserve the designated high-pressure side.
- No mounting bracket is included, and the process connection is M20×1.5 DIN 16288 male process connection.
- After mechanical work, perform leak testing, zero trim and loop verification without exceeding the capsule limits.
- The maintenance host must use a device description compatible with the installed BRAIN electronics generation.
- Read and record the live electronics revision before loading parameters or selecting a replacement amplifier assembly.
- After service, verify that the restored configuration matches the physical C capsule and M20 DIN process connection.