Features:
- The B-capsule direct-mount configuration with local indication uses the 0.1 to 2 MPa (14.5 to 290 psi) capsule, direct-mount pressure connection and 1/2 NPT female, two entries with blind plug.
- The B-capsule direct-mount configuration with local indication provides 4–20 mA DC with digital communication through HART 5/HART 7 protocol, with digital indicator.
- The B-capsule direct-mount configuration with local indication combines 1/2 NPT female process connection, 316L SST process connector with Hastelloy C-276 diaphragm and 316 SST 2-inch pipe bracket.
EJA530E-JBS4N-017DL is the complete ordering identity for the configuration defined by B capsule code (0.1 to 2 MPa), 1/2 NPT female process connection and digital indicator.
It converts gauge pressure into a control-system signal and supports configuration or diagnostic access through HART 5/HART 7 protocol.
Before commissioning, verify electrical entry, indicator type or mounting bracket against the installed equipment and project documentation.
Availability is subject to Apter Power inventory and sourcing confirmation.
Verified resources for Yokogawa EJA530E-JBS4N-017DL:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- The B-capsule direct-mount configuration with local indication measures liquid, gas or steam line pressure through a direct process-mounted connection.
- The B-capsule direct-mount configuration with local indication supports pump, compressor, vessel or header pressure monitoring in an engineered control loop.
- The B-capsule direct-mount configuration with local indication provides a primary pressure variable and diagnostic status for process control or asset monitoring.
- Back up range, damping, output mode, alarm direction and tag data before changing transmitter electronics.
- Any host update must retain support for the installed HART revision and the diagnostic variables used by the control system.
- After restoration, compare the downloaded configuration with the physical capsule, process connection and indicator selection.
- The enclosure is intended for indoor or outdoor industrial use within -40 to 85°C (-40 to 185°F), or -30 to 80°C with LCD under pollution degree 2 conditions.
- Process exposure must remain compatible with 316L SST process connector with Hastelloy C-276 diaphragm and the selected fill-fluid requirements.
- Vibration, impulse-line support and the direct-mount pressure connection position must remain within the official mounting guidance.
,
- Isolation and depressurization are required before disturbing the 1/2 NPT female process connection.
- Wetted-material compatibility must be confirmed for 316L SST process connector with Hastelloy C-276 diaphragm to prevent leakage or diaphragm damage.
- No approval-specific option suffix is included; use the exact nameplate and base documentation to determine the applicable limits.