Features:
- The H-capsule cover-flange configuration uses the 5 to 500 kPa (20 to 2000 inH2O) capsule, horizontal piping with left-side high pressure and 1/2 NPT female, two entries with blind plug.
- The H-capsule cover-flange configuration provides 4–20 mA DC with digital communication through HART 5/HART 7 protocol, with digital indicator.
- The H-capsule cover-flange configuration combines 1/4 NPT female cover-flange pressure ports without separate process connectors, S-code wetted assembly with Hastelloy C-276 diaphragm and 304 SST flat 2-inch pipe bracket.
Use the full EJA110E-JHS5J-917DB code when matching the configuration defined by H capsule with cover-flange pressure ports and digital indication.
It measures differential and static pressure for engineered flow, level, density or equipment-monitoring duties, with remote access through HART 5/HART 7 protocol.
The replacement review must resolve cover-flange ports, H capsule or impulse-piping layout before the equipment is returned to service.
Availability is subject to Apter Power inventory and sourcing confirmation.
Verified resources for Yokogawa EJA110E-JHS5J-917DB:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- The H-capsule cover-flange configuration measures differential pressure across a primary flow element, filter, heat exchanger or vessel connection.
- The H-capsule cover-flange configuration supports inferred flow, level or density calculations when the impulse-piping and manifold design are validated.
- The H-capsule cover-flange configuration provides differential and static-pressure information for process control, protection or condition monitoring.
- The assembled housing is rated IP66/IP67, Type 4X when covers, plugs and the 1/2 NPT female, two entries with blind plug entry are correctly sealed.
- When reviewing environmental ratings, the rating does not extend to an incorrectly fitted process connector or an open conduit path.
- In the documented environmental ratings context, any approval suffix, coating option or stainless housing selection must be read from the complete order code before installation.
- For compliance, the transmitter family is designed to the applicable EN 61010 safety and EN 61326 EMC requirements listed by Yokogawa.
- When reviewing compliance, installed compliance depends on retaining the IP66/IP67, Type 4X enclosure, approved entries and specified process materials.
- In the documented compliance context, any hazardous-location claim must be supported by the exact option suffix and matching nameplate rather than the base family alone.
- The selected electronics carry HART 5/HART 7 protocol data on the documented 4–20 mA DC with digital communication measurement loop.
- Digital communication is commissioned within a total loop-load range of 0 to 1290 Ω, with 250 to 600 Ω required for digital communication; verify the exact loop voltage at the transmitter terminals.
- Remote parameter access must use a host and device description that support the EJA110E DPharp EJA Series communication revision.