Features:
- The C-capsule direct-mount configuration uses the 0.5 to 10 MPa (72.5 to 1450 psi) capsule, direct-mount pressure connection and 1/2 NPT female, two entries with blind plug.
- The C-capsule direct-mount configuration provides 4–20 mA DC with digital communication through HART 5/HART 7 protocol, with digital indicator.
- The C-capsule direct-mount configuration combines 1/2 NPT female process connection, 316L SST process connector with Hastelloy C-276 diaphragm and 316 SST 2-inch pipe bracket.
For EJA530E-JCS4N-017DL, the order code combines C capsule code (0.5 to 10 MPa) with the -017DL electrical, display and bracket configuration as one matched configuration.
It converts gauge pressure into a control-system signal and supports configuration or diagnostic access through HART 5/HART 7 protocol.
Installation approval should include a documented check of capsule range, process pressure rating or calibrated endpoints and the connected system.
Availability is subject to Apter Power inventory and sourcing confirmation.
Verified resources for Yokogawa EJA530E-JCS4N-017DL:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- The C-capsule direct-mount configuration measures liquid, gas or steam line pressure through a direct process-mounted connection.
- The C-capsule direct-mount configuration supports pump, compressor, vessel or header pressure monitoring in an engineered control loop.
- The C-capsule direct-mount configuration provides a primary pressure variable and diagnostic status for process control or asset monitoring.
- The receiving system must support HART 5/HART 7 protocol over the selected 4–20 mA DC with digital communication output and the applicable device revision.
- Mechanical replacement requires the same 1/2 NPT female process connection, pressure capsule and high-pressure-side orientation.
- The digital indicator and 316 SST 2-inch pipe bracket must fit the existing access, visibility and pipe-mounting plan.
- Self-diagnostics supervise CPU, hardware, configuration and measurement-overrange conditions during operation.
- Diagnostic status is available through HART 5/HART 7 protocol and must be mapped separately from the primary pressure value.
- A replacement check should verify capsule-temperature and process-alarm behavior for the selected 0.5 to 10 MPa (72.5 to 1450 psi) span.
- Performance is based on the selected 0.5 to 10 MPa (72.5 to 1450 psi) capsule and the calibrated range established inside -0.1 to 10 MPa (-14.5 to 1450 psi).
- The documented response characteristic and stability of ±0.1% of URL for 10 years apply under the official reference conditions.
- Accuracy effects from ambient temperature, static pressure and mounting position must be included in the loop uncertainty review.