Features:
- Kinetix 5100 200 V-class configuration for the 2198-E1020-ERS catalog number
- Standard I/O and auxiliary feedback connections for documented system integration
- Two RJ45 EtherNet/IP ports and a dedicated Safe Torque Off connection
Allen-Bradley
2198-E1020-ERS accepts 95...132 V rms single-phase input for 1.0 kW output, or 170...253 V rms single-phase or three-phase input for 2.0 kW output.
Its 13.4 A rms continuous output and 40.58 A rms peak output for up to 1.8 seconds identify this catalog configuration. Actual axis performance depends on the selected motor, feedback hardware, load inertia, duty cycle, and regeneration.
Confirm controller mode, motor/feedback compatibility, branch protection, wiring, cooling, grounding, cable clearance, axis duty, and Safe Torque Off requirements before selection.
Availability, condition, price, and shipping time for 2198-E1020-ERS are confirmed during quotation.
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- The drive display presents status information and fault codes for local review
- For 120/230 V single-phase input, Rockwell Automation lists the LPJ-40SP fuse and 1489-M2D400 circuit breaker
- For 230 V three-phase input, Rockwell Automation lists the LPJ-35SP fuse and 1489-M3D300 circuit breaker
- Maximum published power loss is 139.83 W at the documented test condition
- Published line-loss ride-through is 20 ms
- The internal shunt is rated 20 ohms with 20 W continuous shunt power
- ControlFLASH Plus software is supported for upgrading Kinetix 5100 drive firmware
- ControlFLASH software is also documented as a firmware-upgrade method
- Inhibit the module before the upgrade and verify the installed firmware after the procedure
- Single-axis indexing applications sized for the documented 1.0 kW rating at 120 V single-phase
- Single-axis indexing applications sized for the documented 2.0 kW rating at 230 V single-phase or three-phase
- Standalone or controller-based Kinetix 5100 motion systems using supported control modes and matched motor/feedback hardware
Use current Rockwell Automation sizing and design resources to validate the actual torque-speed profile, duty cycle, regeneration, motor and feedback interfaces, controller, protection, cabling, enclosure cooling, grounding, and Safe Torque Off requirements.