- Frame 1 Kinetix 5500 drive for one Logix-integrated motion axis
- Integrated Motion over EtherNet/IP supports coordinated controller-based motion
- Hardwired Safe Torque Off terminals connect to a separately validated safety circuit
Allen-Bradley 2198-H003-ERS supports one servo axis in a Kinetix 5500 system and is selected as part of a complete controller, motor, feedback, brake, and cable combination.
The applicable operating point depends on whether the installation uses 230 V single-phase, 230 V three-phase, or 480 V three-phase input.
Confirm the complete catalog number, controller and drive firmware, motor-feedback pairing, approved cables, protection, regeneration, grounding, enclosure airflow, and Safe Torque Off validation before commissioning.
Availability, condition, price, and shipping time for 2198-H003-ERS are confirmed during quotation.
Allen-Bradley 2198-H003-ERS Kinetix 5500 Servo Drive Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- KTK-R-2 is documented for the 240 V single-phase branch-circuit condition
- KTK-R-3 is documented for the 240 V and 480 V three-phase conditions
- Solid-state motor overload protection is provided by the drive
- Install the drive upright to maintain the documented airflow path
- Provide 40 mm clearance above and below; no left/right clearance is required
- Use M4 (#8-32) steel screws and do not exceed 2.0 N·m mounting torque
- DSL feedback and motor-temperature data share the documented single motor cable
- Motor and feedback catalog numbers must be selected from supported combinations
- Brake and feedback interfaces must match the selected motor and cable set
- Single-axis Kinetix 5500 motion controlled through a supported Logix controller
- 230 V single-phase installations using the documented 0.2 kW operating point
- Three-phase installations using the documented 230 V or 480 V operating point