Features:
- Compact display: two lines of 20 characters for operator messages
- RS-485 networking: documented controller communication through supported interfaces
- Application storage: configurable screens, entries and alarm interaction
2707-M485P3 brings basic data entry and status presentation to legacy serial control systems without a graphical HMI footprint.
The terminal only becomes a functional replacement when its application, controller addresses, RS-485 settings and transfer method are preserved.
A practical service file combines the DTAM project, cable record, software release, node settings, wiring diagram and tested communication result.
Availability of 2707-M485P3 is subject to Apter Power inventory and sourcing confirmation.
Allen-Bradley 2707-M485P3 DTAM Micro RS-485 Operator Interface Manuals, Datasheets, and Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Controller route: identify the PLC-5, SLC or MicroLogix interface in use.
- Node settings: preserve addressing and protocol parameters.
- Cable distance: remain within the published limit for the actual interface.
- Termination: match shielding, grounding and network-end practice to the drawing.
- PLC mapping: retain every data address used by the DTAM screens.
- Message behavior: verify numeric entry, status and alarm transactions.
- Serial settings: align protocol, rate and node configuration.
- Recovery test: prove read and write functions before production release.
- DPS software: confirm 2707-NP Series H or later access.
- Transfer cable: use the documented 2707-NC5 connection.
- Archive: upload and validate the current application before removal.
- Acceptance: test screens, entries, alarms and controller communication.
- Machine status: present compact controller messages to an operator.
- Numeric entry: write approved setpoints through the serial application.
- Legacy panels: retain DTAM interaction with supported PLC communication paths.