Features:
- Provides the S300 Safety Controller SIL 3 configuration for Honeywell Safety Manager SC.
- Uses increased controller memory required for Safety Manager SC DNP3 outstation functionality.
- Replaces FC-SCNT01 with documented pin-to-pin and backward compatibility in supported systems.
The current ordering configuration is Honeywell
FC-SCNT02 51460114-176, the S300 Safety Controller SIL 3 for Safety Manager SC.
It executes the Safety Manager SC control application and provides the controller hardware required when DNP3 outstation communication is configured.
Before replacement, verify Safety Manager SC release R200.2 or later, the redundant partner arrangement, controller labeling and project-specific hazardous-area approvals.
Availability is subject to Apter Power inventory and verification of part number 51460114-176.
Honeywell FC-SCNT02 51460114-176 manuals and reference links:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Honeywell FC-SCNT02 51460114-176 General Specifications
General
- ManufacturerHoneywell
- ModelFC-SCNT02 51460114-176
- ConditionNew original ready stock
- Product FamilySafety Manager SC
- FC-SCNT02 is documented as a pin-to-pin and backward-compatible replacement for the earlier FC-SCNT01 controller.
- An FC-SCNT02 can operate with an FC-SCNT01 partner in the same redundant Safety Manager SC controller arrangement.
- Honeywell supports FC-SCNT02 from Safety Manager SC release R200.2, so the installed system release must be checked before replacement.
- FC-SCNT02 provides the controller hardware required when Safety Manager SC is configured as a DNP3 outstation.
- The increased memory capacity supports the additional controller resources used by the DNP3 implementation.
- DNP3 operation is tied to the supported Safety Manager SC release and must be enabled through the documented system configuration.
- The controller is identified by Honeywell as the S300 Safety Controller SIL 3 for Safety Manager SC applications.
- The product label carries CSA, ATEX and IECEx hazardous-location markings for the exact 51460114-176 configuration.
- The nameplate states an ambient temperature range of -40 to +70 degrees C for the marked installation conditions.