Features:
- Balanced 8 mm lead: The screw selection combines moderate speed with increased load and thrust capability.
- AQ seal option: The suffix identifies the documented sealing configuration for the actuator.
- Extended cable reach: A 5 m cable supports cabinet layouts beyond the standard 3 m arrangement.
This order code is distinguished by its 300 mm stroke, medium lead and AQ option rather than by the shared 60 W motor rating.
The actuator converts the T1 controller command into linear motion while the machine enclosure manages the wider environmental boundary.
A replacement review should combine payload direction, seal requirement and the longer cable route before releasing the order.
Apter Power can assist with sourcing the IAI ISA-SYM-I-60-8-300-T1-M-AQ ISA-SYM Single-Axis Robot after the AQ option and 5 m cable requirement are established.
IAI ISA-SYM-I-60-8-300-T1-M-AQ ISA-SYM Single-Axis Robot Manuals,Datasheets,Link
Important Notice: No qualified exact-model English PDF is attached. Use the complete product model in every document request.
- Medium-lead balance: The 8 mm screw provides a different speed-versus-thrust choice from adjacent ISA-SYM variants.
- Mounting attitude: Select payload limits from the horizontal or vertical operating case, not a combined figure.
- Dynamic margin: Include tooling mass and acceleration when setting the permitted operating profile.
- Thrust boundary: Avoid substituting the high-speed 16 mm-lead profile when the machine depends on this thrust class.
- AQ scope: Treat the seal option as one element of the complete machine contamination strategy.
- Connector protection: Keep cable and connector areas inside the documented enclosure conditions.
- Slider inspection: Remove contamination that could be carried into the moving interface during service.
- Exposure stop: Escalate washdown, immersion or aggressive-fluid duty instead of assuming AQ covers it.
- Five-metre reach: Use the M cable option without stretching the connector or bypassing strain relief.
- Moving bend: Route cable motion through the machine-approved carrier and bend radius.
- Noise separation: Keep feedback and actuator cabling away from high-energy switching conductors.
- Service trace: Record the original route before removing the installed axis from the machine.
- Moderate-speed transfer: Serves linear handling tasks that need more thrust than the high-speed lead option.
- Vertical positioning: Supports vertically mounted axes within the documented payload limit.
- Contamination-managed cells: Fits enclosed equipment that specifies the AQ actuator option.
- Remote cabinet layouts: Provides the documented 5 m cable arrangement for separated controls.