Features:
- 32 MHz MC68040 processor
- 4MB shared DRAM
- No SCSI or Ethernet
Motorola identifies MVME162-510A as an MVME162FX VME Embedded Controller for compatible embedded control systems. The documented code distinguishes this no-SCSI, no-Ethernet assembly from the adjacent storage and network variants.
The documented ordering configuration combines 4MB DRAM with no onboard SCSI or Ethernet. Four independent DMA channels serve the IndustryPack interfaces, while VMEbus D64 and local-memory burst operation support deterministic I/O movement.
Verify power, airflow, P1/P2 connections, serial settings, and transition hardware before installation. Confirm the no-SCSI, no-Ethernet assembly and every installed IndustryPack module against the official Motorola configuration before commissioning.
The Motorola VME MVME162-510A MVME162FX VME Embedded Controller is listed as Active / Available from OEM. Contact Apter Power for quotation, official documentation, and configuration review.
Motorola VME MVME162-510A MVME162FX VME Embedded Controller Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Motorola VME MVME162-510A MVME162FX VME Embedded Controller Specs
General
- ManufacturerMotorola VME
- ModelMVME162-510A
- ConditionNew Original ready stock
- Product FamilyMVME162FX 400/500 Series
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Onboard memory resources
- Main memory: 4MB shared DRAM
- Backup memory: 512KB SRAM with battery backup
- Firmware storage: 1MB Flash memory
- NVRAM / clock: 8K x 8 NVRAM with time-of-day clock
Communication and expansion resources
- Network: No onboard Ethernet interface
- Storage: No onboard SCSI interface
- Serial I/O: Two serial communication ports
- IndustryPack: Four IndustryPack ports
Chassis and commissioning checks
- Chassis: Use a compatible double-high VME chassis
- Backplane: Verify P1 and P2 connector requirements
- Serial I/O: Confirm serial-interface and transition-module settings
- Cooling: Provide forced-air cooling for the stated operating range