Features:
- Seven RJ45 ports connect 10/100 Mbit/s Industrial Ethernet devices.
- Three single-mode SC ports provide 1000 Mbit/s optical uplinks.
- A removable C-PLUG retains the managed-switch configuration.
Siemens 6GK5307-3BM00-2AA3 separates copper access connections from single-mode optical backbone paths.
Its managed switching and redundancy functions control how traffic is forwarded when the network topology changes.
The 24 V DC supply and IP30 enclosure place the switch inside a protected industrial cabinet.
The Siemens 6GK5307-3BM00-2AA3 SCALANCE X307-3LD Managed Industrial Ethernet Switch may still be available for purchase and support from Apter Power beyond End-Of-Life (EOL) by the manufacturer (OEM).
Siemens 6GK5307-3BM00-2AA3 SCALANCE X307-3LD Managed Industrial Ethernet Switch Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Copper and Fiber Port Roles
- Electrical access: Seven RJ45 ports attach 10/100 Mbit/s plant devices to the managed switch.
- Optical uplinks: Three SC ports carry 1000 Mbit/s traffic over single-mode fiber.
- Traffic transition: The switch forwards frames between the copper edge and optical backbone without an external media converter.
- Service access: Front-facing interfaces keep cable identification and maintenance at the cabinet side of the installation.
Single-Mode Fiber Paths
- Connector format: Each optical channel terminates at an SC interface for the specified single-mode fiber path.
- Uplink rate: The optical channels operate at 1000 Mbit/s, above the 10/100 Mbit/s copper access rate.
- Backbone separation: Fiber uplinks carry inter-switch traffic independently from local RJ45 device connections.
- Port planning: The three optical paths allow multiple fiber directions without consuming an electrical access port.
Managed Network Continuity
- Redundancy manager: The switch can supervise the configured redundant network path.
- Topology response: Managed forwarding changes the active traffic route when the supervised path state changes.
- PROFINET status: PROFINET IO device operation exposes the switch within the automation network configuration.
- Stored setup: C-PLUG media keeps the switch configuration available for controlled hardware replacement.
Cabinet Power and Environment
- Supply input: A 24 V DC source powers the switching electronics and all installed interfaces.
- Thermal range: Operation from -40 to +60 °C supports protected industrial cabinet locations.
- Enclosure limit: IP30 protection requires an installation that prevents exposure to water and excessive dust.
- Cable routing: Copper and fiber leads should remain identifiable because the two media types serve different network roles.