Features:
- CUVC generation: closed-loop and open-loop vector control for MASTERDRIVES
- Firmware identity: the exact article is specified with V3.4
- Integrated feedback: HTL encoder and PTC/KTY84 motor-temperature connections
6SE7090-0XX84-0AB0 is the CUVC controller that coordinates vector-control functions inside a SIMOVERT MASTERDRIVES converter.
Its serial interfaces separate local commissioning through a PC or OP1S from drive-network communication over USS.
Analog, digital, encoder, and temperature-sensor connections place the board at the junction between the parameter set and the motor feedback chain.
Apter Power can review the 6SE7090-0XX84-0AB0 CUVC identity, firmware, condition, and drive-service requirements.
Siemens 6SE7090-0XX84-0AB0 SIMOVERT MASTERDRIVES CUVC Vector Control Module Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Platform: the module belongs to SIMOVERT MASTERDRIVES.
- Controller type: Siemens identifies it as CUVC.
- Operating methods: closed-loop and open-loop vector control are supported.
- Firmware: the exact article is associated with Version V3.4.
- Local connection: RS-232/RS-485 supports a PC or OP1S.
- Drive network: a separate RS-485 interface supports USS.
- Parameter recovery: the saved drive set belongs to the installed converter configuration.
- Migration boundary: another controller generation is not an automatic substitute.
- Encoder: an HTL unipolar pulse input is provided.
- Temperature: PTC and KTY84 motor sensors are supported.
- Digital signals: configurable and dedicated digital channels connect control logic.
- Analog signals: current or voltage inputs and outputs support process references.
- SIMOVERT MASTERDRIVES vector control: execute the converter’s closed-loop or open-loop motor-control strategy.
- HTL encoder feedback: connect the documented unipolar speed-feedback signal.
- Motor thermal supervision: receive PTC or KTY84 sensor information.
- Legacy drive maintenance: restore a V3.4 CUVC configuration with its saved parameter set.