Features:
- Produces a stabilized 24 V DC output rated at 10 A.
- Accepts single-phase 120/230 V AC through automatic range selection.
- Uses a DIN-rail IP20 design for industrial control cabinets.
The exact article is the 240 W PSU8200 version with a regulated 24 V DC output.
It establishes the control-power rail for PLCs, interfaces and field electronics in a panel.
Calculate steady-state and start-up demand, then confirm protective devices and clearances for the installed mains system.
The active PSU8200 article is supplied subject to Siemens channel and Apter Power stock confirmation.
Verified resources for Siemens 6EP3334-8SB00-0AY0:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Feed controller racks and interface equipment from a regulated 24 V cabinet bus.
- Power industrial sensors, relays and communication devices within the calculated load budget.
- Standardize auxiliary DC distribution in machinery and process-control panels.
- The rated output provides 240 W at 24 V DC and 10 A.
- Regulation maintains the documented DC output across the permitted input range.
- Thermal derating must be considered when cabinet conditions exceed the standard range.
- The enclosure is intended for DIN-rail installation in a protected cabinet.
- Protective-earth continuity and upstream branch protection are required before service.
- Ventilation clearances must remain unobstructed by adjacent heat-producing equipment.
- Automatic input-range handling supports the documented 120/230 V AC networks.
- Conductor and protective-device selection must follow the actual supply and applicable installation rules.
- Inrush current and downstream start-up demand must be considered during system commissioning.