Features:
- Switches sixteen 24 V DC source outputs at up to 0.5 A per channel from two controller output bytes.
- Applies mounting-temperature derating to the combined output current while retaining the per-channel limit.
- Reports module supply, wire-break and short-circuit conditions through DIAG, PWR and channel indicators.
Siemens 6ES7132-6BH00-0BA0 turns sixteen SIMATIC ET 200SP output bits into field-load switching paths.
The BU type A0 supplies the terminal and backplane connection, while CC00 identifies the module-specific color coding.
Load type sets the maximum switching frequency, and the installation temperature limits the total current shared across the module.
The Siemens 6ES7132-6BH00-0BA0 DQ 16x24VDC/0.5A ST Digital Output Module may still be available for purchase and support from Apter Power beyond End-Of-Life (EOL) by the manufacturer (OEM).
Siemens 6ES7132-6BH00-0BA0 DQ 16x24VDC/0.5A ST Digital Output Module Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Sixteen source-output paths
- Controller data: Two output bytes carry the sixteen commanded states from the controller.
- Positive switching: An active channel switches the 24 V positive potential to its load.
- Channel current: Each path is rated for 0.5 A.
- Shared limit: The complete module must remain within the applicable total-current curve.
Temperature-dependent load
- Horizontal 40 °C: The module can carry a total of 8 A.
- Horizontal 50 °C: The total falls to 6 A.
- Horizontal 60 °C: The total falls to 4 A.
- Vertical mounting: The 8 A point applies at 30 °C, followed by the documented 6 A and 4 A limits.
Group fault reporting
- Short circuit: A fault on an output contributes to the module diagnostic condition.
- Wire break: Wire-break monitoring is included in the documented module diagnostics.
- Supply voltage: Loss of the output supply is monitored separately from the output commands.
- Indicators: Channel LEDs show commanded states while the DIAG LED reports the module condition.
A0 mounting and coding
- BaseUnit: BU type A0 provides the terminal base for this module.
- Color code: CC00 identifies the module-specific terminal assignment.
- Backplane data: Two output bytes reach the electronics through the ET 200SP backplane.
- Successor check: A 6BH01 replacement must be validated against the existing terminals and project settings.