- Modular integrated axis power section for Kinetix 6200 or Kinetix 6500 control hardware
- Converter capacity supplies the IAM inverter and permitted additional Bulletin 2094 rail axes
- Separate control, feedback, motor-power, and network interfaces support serviceable system integration
2094-BC02-M02-M combines line-side conversion and one servo inverter position in a modular Kinetix 6200/6500 power-rail assembly.
Its system role is to establish the shared DC supply for the installed axis set while a separately selected control module defines communication, feedback, and safety behavior.
Review all connected loads, regenerative duty, rail layout, control and motor hardware, firmware, conductors, connectors, clearances, and cooling as one engineered configuration.
Availability, condition, price, and shipping time for 2094-BC02-M02-M are confirmed during quotation.
Allen-Bradley 2094-BC02-M02-M Kinetix 6200/6500 Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- The IAM converter must be sized for its own inverter and every additional axis connected to the power rail
- Total connected bus capacitance must remain within the limits of the selected Bulletin 2094 supply architecture
- Regenerative energy and shunt loading must be calculated from the complete machine duty cycle
- AC line input, control power, motor power, and feedback connections use separate documented terminal and connector groups
- Motor-power and feedback cables must meet the supported catalog, length, shielding, and bend-radius requirements
- Cable shields and bonding points must be terminated according to the Bulletin 2094 installation instructions
- Kinetix 6200 commissioning uses the supported SERCOS interface controller and compatible drive firmware
- Kinetix 6500 commissioning uses Integrated Motion over EtherNet/IP with the supported Logix controller environment
- The selected motor, feedback, polarity, safety circuit, and axis parameters must be verified before enabling motion
- Modular Kinetix 6200 systems requiring an IAM converter and one medium-current SERCOS-controlled axis
- Modular Kinetix 6500 systems requiring an IAM converter and one EtherNet/IP-controlled axis
- Bulletin 2094 multi-axis power rails whose combined load is within the IAM converter and shunt design limits