- Frame 1 Kinetix 5500 drive for one controller-based motion axis
- Dual Ethernet ports support the documented Integrated Motion over EtherNet/IP connection
- Hardwired Safe Torque Off is wired into the machine safety architecture
Allen-Bradley 2198-H008-ERS is selected with a supported Logix controller, motor, DSL feedback device, brake interface, and approved 2090 cable.
Its three documented supply conditions lead to different output-power operating points, so the actual machine supply must be established before axis sizing.
Review the load profile, regeneration, controller and firmware, branch protection, grounding, shield bonding, enclosure airflow, and safety circuit as part of the complete design.
Availability, condition, price, and shipping time for 2198-H008-ERS are confirmed during quotation.
Allen-Bradley 2198-H008-ERS Kinetix 5500 Servo Drive Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Mains conductors use the documented 1.5...4 mm² range and 7.0 mm strip length
- Motor conductors use the documented 0.75...2.5 mm² range and 8.0 mm strip length
- Mains and motor terminals use the documented 0.5...0.6 N·m torque range
- Drive status and fault information are available through the Logix motion connection
- Motor-temperature information is monitored through the supported DSL connection
- Solid-state motor overload protection retains the documented thermal model
- Bond the drive and enclosure according to the Kinetix 5500 installation instructions
- Terminate cable shields with the documented clamps and connector hardware
- Verify the grounding-screw configuration for the installed power-source arrangement
- Single-axis motion requiring Logix integration over EtherNet/IP
- 230 V installations using the documented single-phase or three-phase operating point
- 480 V three-phase installations using the documented 1.6 kW operating point