Features:
- Armored cable: Flexible stainless-steel armor protects the 0.5 m integral lead through exposed routes.
- Compact 30 mm case: The short M10 x 1 body limits mechanical reach at the mounting port.
- Extension-cable system: The half-metre lead is combined with the correct extension cable for the required electrical length.
This compact case is selected where port clearance is limited but the cable route benefits from stainless-steel armor.
The armor protects the lead along the route; its transitions still need support so load is not transferred to the probe body or ClickLoc joint.
Mechanical case length and electrical system length are separate choices and should be matched independently.
Apter Power supplies Bently Nevada 330104-00-03-05-02-00 3300 XL 8 mm Probe documentation, quotations and armored-route configuration review.
Bently Nevada 330104-00-03-05-02-00 3300 XL 8 mm Probe Manuals,Datasheets,Link
Important Notice: Match the complete code, M10 x 1 port, case reach, electrical system length and site approval requirements before installation.
- Flexible armor: Stainless-steel armor protects the 0.5 m integral lead from mechanical contact.
- Transition points: Support both ends of the armor so bending force does not reach the cable entry or connector.
- Route planning: Keep the armored lead clear of sharp edges and moving parts.
- Inspection: Check the armor for crushing, pulled fittings or exposed cable before commissioning.
- Thread interface: M10 x 1 standard-mount case for the 3300 XL 8 mm system.
- Unthreaded section: The code specifies no unthreaded reach ahead of the mounting thread.
- Compact body: The 30 mm overall case suits shallow mounting envelopes.
- Clearance: Confirm the port shoulder leaves the sensing tip at the required target position.
- Port seal: Use the installation seal specified for the machine housing and process environment.
- Armor limit: Cable armor provides mechanical protection but does not replace environmental sealing.
- System chain: Complete the probe with the documented extension cable and Proximitor sensor.
- ClickLoc joint: Keep the unprotected connection clean, dry and fully seated.
- Fluid-film bearing points: Relative shaft-vibration measurement on turbines, compressors, pumps and motors.
- Axial-position channels: Static displacement measurement against a conductive target with the documented probe orientation.
- Keyphasor reference: Once-per-turn phase reference where target geometry and channel setup follow the monitoring design.
- Speed measurement: Rotational-speed sensing when the 3300 XL 8 mm signal is accepted by the configured monitor channel.