Features:
- Provides a 15 ft connection between a VP8 sensor and the analyzer wiring.
- Carries measurement, temperature and solution-ground circuits in one assembly.
- Allows the sensor to disconnect from the installed cable during maintenance.
This order number is the interconnecting cable, not the pH sensor or analyzer.
Its conductors preserve the low-level electrochemical signal and auxiliary sensor circuits over the documented length.
Connector condition and analyzer terminal mapping must be checked before reuse or replacement.
Apter Power can review sourcing, documentation and system matching for 24281-00.
Verified resources for Emerson Rosemount 24281-00:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- New 3900VP installations use the cable to reach a nearby panel-mounted liquid analyzer.
- Maintenance teams can leave the cable in place while exchanging a fouled or exhausted VP sensor.
- Skid builders can route one defined assembly from the process connection to the instrument enclosure.
- The sensor end uses the keyed VP8 detachable connector.
- Individual analyzer-side conductors terminate measurement and auxiliary circuits.
- The 15 ft length defines the available route between sensor and transmitter.
- Cable routing should remain separated from high-voltage and variable-frequency-drive conductors.
- The VP8 connector must remain dry and fully engaged after sensor installation.
- Strain relief prevents process vibration from loading either termination.
- Shielding protects the high-impedance pH circuit from coupled electrical noise.
- Clean insulation limits leakage current that could shift the measured millivolt signal.
- Correct temperature and solution-ground terminations preserve compensation and diagnostics.