Features:
- Identifies the AEB revision of the GDPA high-frequency power supply board.
- Combines input rectification, regulation and high-frequency inverter stages.
- Feeds isolated gate-drive power outputs within the documented GE drive architecture.
The full AEB suffix identifies the requested revision of the GDPA high-frequency supply board.
Its conversion stages provide isolated power for the gate-drive and associated control circuits in the excitation system.
Input source, connectors, revision, discharge state and companion assembly must be confirmed before board exchange.
Revision-controlled GE drive boards are offered after the complete installed label is verified.
Verified resources for GE DS200GDPAG1AEB:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Generate isolated gate-drive supplies within supported EX2000 excitation equipment.
- Provide the regulated high-frequency power path for associated control circuits.
- Restore an excitation power-supply assembly after the external cause of failure is corrected.
- Incoming AC or DC power passes through the documented rectifier and filter stage.
- A buck regulator establishes the controlled DC bus for conversion.
- The 27 kHz inverter drives the transformer that develops isolated output supplies.
- Protective functions supervise the power-conversion stages described by GE.
- The factory-set frequency reference should not be altered during routine replacement.
- Stored-voltage checks are required before connector or component contact.
- The AEB suffix must correspond to the installed board identity.
- Connector population and companion assembly must be compared with the removed board.
- A base DS200GDPA match alone does not prove functional interchangeability.