Features:
- Provides eight OUT terminals and eight RTN terminals for current-output field wiring.
- Includes terminal connections for redundant 24 VDC loop-power supplies.
- Supports the documented Tricon analog-output and HART output-interface arrangements.
The current ordering configuration is the 9853-610 basic eight-point current-output termination panel for 4–20 mA field wiring.
It forms the field-termination interface between the supported Tricon analog-output path and connected valves, positioners or other current-loop devices.
Provide at least one RTN connection, fit a shorting jumper on every unused point and verify the exact host architecture before connecting the panel.
Availability is subject to Apter Power stock verification and sourcing confirmation.
Verified resources for Triconex 9853-610:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Triconex 9853-610 Current Output Termination Panel Specs
General
- ManufacturerTRICONEX
- Model9853-610
- ConditionNew Original ready stock
- Product FamilyTricon Analog Output Termination Panels
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Terminates eight 4–20 mA field-output loops through dedicated OUT and RTN points.
- Connects the documented commoned-return, DC-coupled TMR analog-output path to field devices.
- Supports HART field-device wiring when used in the approved HART output-interface arrangement.
- Uses the host module's LOAD indication to identify a point that cannot drive current, including an open field loop.
- Relies on Pwr1 and Pwr2 indications to show loop-power presence above 20 VDC, not adequacy for the connected load.
- Requires continuity, RTN and unused-point jumper checks before a field-loop condition is assigned to the panel.
- Retain at least one RTN connection during rewiring; more than one return connection is allowed by the official diagram.
- Install the required shorting jumper on every unused point before returning the loop assembly to service.
- Match the eight-point current-output or HART host architecture and exact panel suffix before ordering a maintenance replacement.