- Confirm the DKC01.3 hardware generation before replacing a visually similar DKC01.1 controller
- Match the 200–480 V single- or three-phase supply arrangement to the installed machine
- Check the .3-generation firmware, parallel I/O and bleeder-group design as one engineered configuration
DKC01.3-040-7-FW is a Bosch Rexroth/Indramat ECODRIVE03 controller with a parallel command interface and integrated mains section.
This model accepts one- or three-phase 200–480 V AC. Its documented continuous-current range is 13–16 A at 4 kHz and 9–12.5 A at 8 kHz, with maximum output frequency of 400 Hz or 800 Hz respectively.
Replacement requires the .3-generation connector allocation, firmware release, parameter conversion, motor-feedback data and common-DC-bus arrangement to be checked against the original machine documentation.
Availability, condition, price, and shipping time for DKC01.3-040-7-FW are confirmed during quotation.
Bosch Rexroth DKC01.3-040-7-FW ECODRIVE03 Parallel Controller Manuals, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Match the DKC01.3 nameplate, connector allocation and application-firmware release
- Do not transfer a DKC01.1 project until mains topology and parameter migration have been reviewed
- Verify the installed motor feedback and mechanical fit against the .3-generation axis record
- Copy the original command-voltage range, reference potential, polarity and scaling
- Recreate digital input/output functions and the complete parallel-connector pin assignment
- Check shield bonding and cable routing before diagnosing a command or offset fault
- Keep the controller within the documented ECODRIVE03 group around bleeder-equipped units
- Recalculate DC-bus capacitance, regenerated energy, precharge and branch protection after any lineup change
- Record the number and physical position of bleeder-equipped controllers before adding or exchanging an axis
- ECODRIVE03 machine axes commanded through parallel analog and digital I/O
- Positioning axes that retain DKC01.3 firmware, motor feedback and parameter architecture
- Multi-axis DC-bus groups engineered around the DKC01.3 bleeder arrangement