Features:
- Integrated guide table: The MXQ body combines pneumatic travel with a guided work surface.
- Axial piping: The P configuration routes pneumatic connections from the designated axial side.
- In-line sensing lead: M9BL keeps the 3 m two-wire cable aligned with the switch body.
The complete code identifies a 10 mm-stroke MXQ8 slide plus its piping and sensing configuration, not only the actuator size.
Its system role is short guided pneumatic positioning with a solid-state signal available to the machine control.
A replacement should preserve port access, switch orientation and cable route around the moving equipment.
Apter Power can support enquiries for the SMC MXQ8-10P-M9BL MXQ Air Slide Table after the axial-piping and in-line switch configuration are confirmed.
SMC MXQ8-10P-M9BL MXQ Air Slide Table Manuals,Datasheets,Link
Important Notice: No qualified exact-model English PDF is attached. Use the complete product model in every document request.
- In-line cable exit: M9BL routes the lead in line with the sensor body rather than perpendicular to it.
- Two-wire circuit: Match the input circuit to the documented two-wire solid-state switch arrangement.
- Lead reach: Route the 3 m cable without placing tension on the switch or moving table.
- Clearance proof: Check tooling and guards across the full stroke before fixing the cable path.
- Axial ports: Keep fitting access clear at the piping direction defined by the P code.
- Tube support: Prevent tubing loads from twisting the compact slide body.
- Flow adjustment: Set controlled travel before allowing the table to impact either stroke end.
- Clean supply: Use the machine pneumatic preparation required for the MXQ circuit.
- Mounting surface: Use a flat base so the integrated guide is not distorted during fastening.
- Tooling load: Keep external moments within the selected MXQ8 application limits.
- Stroke clearance: Reserve space for the complete 10 mm table movement and attached workpiece.
- Position acceptance: Test both switch states and mechanical end positions before production cycling.
- Short pick-and-place: Provides compact guided movement between two nearby machine positions.
- Part alignment: Moves a small fixture or workpiece while the table constrains motion.
- Sensor-confirmed transfer: Supplies a solid-state position indication to the control system.
- Space-limited tooling: Fits mechanisms that benefit from an integrated slide-and-guide body.