Features:
- Uses M10 x 1 probe mounting with with armor construction.
- Combines 0 mm unthreaded length, 240 mm case length and a 1.0 m (39 in) probe lead.
- Terminates through 01 = clickloc with connector protector, standard cable.
The current ordering configuration is 330910-00-24-10-01-CN, combining M10 x 1 mounting, with armor, 0 mm unthreaded length, 240 mm overall case and a 1.0 m (39 in) probe cable.
It senses close-clearance shaft motion for compressor vibration, axial-position, timing-reference or speed measurements through a matched 3300 XL NSv transducer system.
Before installation, verify thread engagement, insertion depth, cable type, connector protection, electrical system length, target material and the approval marked on the delivered probe.
Availability is subject to Apter Power inventory and sourcing confirmation.
Verified resources for Bently Nevada 330910-00-24-10-01-CN:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Measures radial shaft vibration in compact compressor or rotating-machine installations.
- Tracks axial shaft position where restricted target size favors the narrow-side-view NSv system.
- Provides Keyphasor, tachometer or zero-speed input from an appropriate rotating target.
- With armor construction must be matched to the installed cable route.
- Strain relief prevents vibration and bend load from reaching the probe-to-cable joint.
- A connector protector limits liquid entry but does not replace proper routing and support.
- Use the matching NSv extension cable and Proximitor Sensor for the selected electrical length.
- Set the initial gap with the machine safely stationary and record the resulting voltage.
- Configure the receiving monitor for the NSv scale factor and intended measurement type.
- Use only approval markings present on the exact delivered ordering identity.
- Maintain enclosure and wiring practices required by the applicable hazardous-area drawing.
- Connector protection is required where condensation, oil or washdown can reach the junction.