Features:
- Performs 2-channel simultaneous dynamic vibration data acquisition and processing with a 24-bit analog-to-digital converter.
- Pairs wirelessly with industrial hazardous-area Android smart devices using high-efficiency Bluetooth communication.
- Delivers high-resolution spectral analysis up to 12,800 lines and maximum frequency range up to 80 kHz for machine diagnostics.
The Bently Nevada SCOUT220-IS is an intrinsically safe portable vibration data collector supplied in brand-new, factory-original condition.
This wireless acquisition module streams dynamic vibration measurements and spectrum recordings into Bently Nevada System 1 software using the S1 Collector app.
Field technicians should utilize the ergonomic shoulder strap with safety breakaways and inspect IEPE sensor connections prior to route collection in hazardous plant zones.
The Bently Nevada SCOUT220-IS is covered by a standard 5-year hardware warranty provided by the manufacturer (OEM).
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Enables route-based portable vibration data collection across rotating equipment assets located in ATEX Zone 0 and Zone 20 areas.
- Executes on-site bearing fault diagnosis, modal impact testing, and two-plane dynamic rotor balancing on critical plant machinery.
- Conducts temporary interval signal capture and bump testing during machinery startup, coast-down, and routine inspection rounds.
- Evaluates sensor bias voltage automatically and alerts field operators in the event of short circuits or disconnected sensor cables.
- Supports patented 6Pack measurement modes to capture low-frequency, high-frequency, and PeakDemod spectra in a single sampling sequence.
- Integrates selectable 2.2 mA sensor excitation current to power ICP and IEPE industrial accelerometers directly.
- Operates within a specified field ambient temperature range of -20 deg C to +55 deg C (-4 deg F to +131 deg F).
- Built with IP65 ingress protection to prevent dust entry and withstand water jet exposure in harsh industrial plants.
- Passes MIL-STD-810F military drop testing from a height of 1.2 meters onto concrete surfaces.
- Holds intrinsic safety certification for Class I, Division 1 hazardous locations according to CSA standards.
- Meets ATEX and IECEx Zone 0 and Zone 20 explosion-proof ratings for flammable gases, vapors, and non-conductive dusts.
- Features an ergonomic shoulder strap equipped with safety breakaways to protect personnel around rotating machinery.