Features:
- Processes contact inputs received from the DTBA and DTBB terminal boards.
- Routes relay and solenoid commands to two TCRA output-board positions.
- Time-tags input state changes before forwarding digital data over IONET.
DS200TCDAG1B operates inside the Mark V digital I/O cores and bridges terminal-board contacts with the control network.
JQ and JR separate the two input-board sources, while JO1 and JO2 divide the contact-output routes to TCRA.
Either shielded JX connection can carry the IONET path, with jumper settings defining termination, board ID and stall-timer behavior.
Apter Power coordinates sourcing and digital-core compatibility support for the General Electric DS200TCDAG1B board.
General Electric DS200TCDAG1B Digital I/O Board Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Input Processing
- DTBA Path: JQ carries contact inputs from DTBA.
- DTBB Path: JR brings the second terminal-board input group.
- State Changes: The board time-tags every detected contact transition.
- Logic Polarity: Input inversions are selected through I/O configuration constants.
Output Distribution
- JO1: Drives the TCRA board in location four where that path is used.
- Q11 Exception: JO1 is unused in Q11 because TCQE directly controls those relays.
- JO2: Carries relay and solenoid commands to the location-five TCRA board.
- Signal Type: The outgoing circuits handle contact-output commands rather than analog values.
Network Connections
- JX1: Provides one shielded twisted-pair IONET connection.
- JX2: Offers the same network function as JX1.
- Core Route: Q11 traffic proceeds through TCEA, while Q51 uses the CTBA path.
- Control Destination: Digital data reaches the appropriate TCQC or control-core interface.
Jumper Assignments
- Termination: J2 and J3 connect the IONET termination resistors.
- Node ID: J4, J5 and J6 set the board's IONET identity.
- Stall Timer: J7 enables the stall-timer function.
- Test Positions: J1 and J8 are reserved for factory testing.