Features:
- Distributes power within the documented Honeywell HPM cabinet assembly.
- Uses the exact 230 V AC execution with two power-supply modules.
- Supports the cabinet's controlled and redundant power-distribution paths.
The assembly distributes incoming AC power and the resulting DC supply paths within the documented Honeywell HPM cabinet configuration.
The 230 V AC feed is routed through the cabinet protection and control path to two power-supply modules. Their outputs are then distributed to the HPM electronics according to the system backplane and harness arrangement.
This is hazardous-voltage distribution hardware. Lock out the incoming source, verify discharge and protective-earth continuity, and match harnesses, breakers and both power-supply modules before energizing the replacement.
Availability is reviewed against the exact 51401135-300 order identity and requested supply condition; manufacturer lifecycle status: Discontinued / Obsolete by OEM.
Verified resources for Honeywell 51401135-300:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- The dual-PSM execution provides the installed hardware path for redundant or load-sharing supply operation as defined by the cabinet design; the distribution assembly itself does not replace controller redundancy logic.
- It is used in TDC 3000/HPM installations that require the exact 230 V AC, two-supply configuration identified by part number 51401135-300.
- Requires lockout, discharge and protective-earth verification before service.
- Routes 230 V AC through cabinet protection to two power-supply modules.
- Distributes resulting DC supplies through the documented HPM backplane and harnesses.
- Lockout, discharge, and protective-earth checks are mandatory before service.
- Uses the documented dual power-supply-module arrangement.
- Fits the documented HPM cabinet power-distribution architecture.
- Breakers and harnesses must match the approved distribution assembly.
- Controls and distributes cabinet power for the documented HPM assembly.
- Complete part-number identity distinguishes the installed distribution hardware.
- Input execution is specified for a 230 V AC source.