Features:
- 300 MHz MPC604 PowerPC processor
- 32MB two-way interleaved, ECC-protected DRAM
- Two PMC sites with front-panel and P2 I/O support
The Motorola MVME2306 ordering code identifies the 32MB memory configuration within the MPC604 section of the MVME2300 Series.
Its VME64 architecture combines protected DRAM, PCI bridging, Ethernet, debug, timers, and VMEbus resources for embedded system control.
Verify the VME slot, P1/P2 connections, PMC power and routing, firmware, and forced-air cooling before placing the module into service.
The Motorola MVME2306 VME Processor Module may still be available for quotation and support from Apter Power beyond manufacturer End-Of-Life (EOL).
Motorola MVME2306 VME Processor Module Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Motorola MVME2306 VME Processor Module Specs
General
- ManufacturerMotorola VME
- ModelMVME2306
- ConditionNew Original ready stock
- Product FamilyMVME2300 Series
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Protected memory resources
- DRAM capacity: The MVME2306 ordering configuration provides 32MB ECC DRAM.
- Memory organization: The Falcon controller architecture uses two-way interleaving with single-bit correction and double-bit detection.
- Flash storage: The platform supplies 1MB through socketed devices and 4MB of surface-mounted Flash memory.
- Local retention: An 8KB NVRAM time-of-day device supports retained parameters and clock functions.
Mezzanine expansion planning
- Onboard capacity: Two IEEE P1386.1 PMC sites accept supported single- or double-width mezzanine cards.
- I/O paths: Compatible PMC functions can route signals through the front panel and/or the VMEbus P2 connector.
- Extended capacity: Optional PMCspan hardware can increase the system total to as many as six PMC positions.
- Power allowance: Installed PMC modules add separate power demand that must be included in the chassis calculation.
Backplane and airflow checks
- Board format: The base board is a double-high VME module measuring 233 mm high, 160 mm deep, and 19.8 mm wide.
- Slot preparation: Check P1, P2, bus-grant continuity, and system-controller selection before seating the MVME2306.
- Cooling range: Motorola specifies 0 to 55 °C entry air with forced cooling of the entire assembly.
- ESD handling: Use grounded antistatic precautions while installing the board or any PMC and PMCspan option.