Features:
- 25 MHz MC68LC040 processor
- 16MB shared DRAM
- SCSI and Ethernet configuration
Motorola identifies MVME162-453 as an MVME162FX VME Embedded Controller for compatible embedded control systems. Its order-code position confirms the 25 MHz 68LC040, 16MB, SCSI, and Ethernet combination.
The ordering configuration combines 16MB DRAM with SCSI and Ethernet while retaining the MVME162 platform I/O architecture. Local-bus DMA supports the VMEbus, SCSI, Ethernet, and each IndustryPack channel without changing the single-slot board concept.
Verify power, airflow, P1/P2 connections, serial settings, and transition hardware before installation. Selection should include the correct MVME712-series transition arrangement when rear P2 peripheral connections are required.
The Motorola VME MVME162-453 MVME162FX VME Embedded Controller is listed as Active / Available from OEM. Contact Apter Power for quotation, official documentation, and configuration review.
Motorola VME MVME162-453 MVME162FX VME Embedded Controller Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Motorola VME MVME162-453 MVME162FX VME Embedded Controller Specs
General
- ManufacturerMotorola VME
- ModelMVME162-453
- ConditionNew Original ready stock
- Product FamilyMVME162FX 400/500 Series
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Onboard memory resources
- Main memory: 16MB shared DRAM
- Backup memory: 512KB SRAM with battery backup
- Firmware storage: 1MB Flash memory
- NVRAM / clock: 8K x 8 NVRAM with time-of-day clock
Communication and expansion resources
- Storage: SCSI interface with local-bus DMA
- Network: Ethernet interface with local-bus DMA
- Serial I/O: Two serial communication ports
- IndustryPack: Four IndustryPack ports
Chassis and commissioning checks
- Chassis: Use a compatible double-high VME chassis
- Backplane: Verify P1 and P2 connector requirements
- Serial I/O: Confirm serial-interface and transition-module settings
- Cooling: Provide forced-air cooling for the stated operating range