Features:
- Standard-mount sensor: The 8.2 mm sensing tip and 40 mm M10 × 1 body fit compact machinery measurement points.
- Five-metre integral cable: The configured self-locking lead provides a direct route to a nearby IQS900 conditioner.
- Industrial sensing assembly: The sensor tip and integral cable are rated IP68, with documented operation from −40 to +180 °C.
Range decision: Pair the probe with the 2 mm or 4 mm IQS900 range required by the machine movement.
Installation decision: Confirm body reach, static gap and protection of the unarmored five-metre cable before commissioning.
Signal decision: Use the conditioned dynamic output for machinery protection or spectral analysis only after the static gap is set.
Apter Power supports Vibro-Meter TQ902-011 111-902-000-011 A1-B1-C40-D2-E5000-F0-G0-H05 with technical documentation, quotations and configuration review.
Vibro-Meter TQ902-011 111-902-000-011 A1-B1-C40-D2-E5000-F0-G0-H05 Proximity Transducer Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Mounting style: TQ902 is the standard-mount sensor in the TQ9x2 proximity family.
- Sensing tip: The 8.2 mm tip is designed for a 2 mm or 4 mm measurement range, depending on the IQS900 configuration.
- Body geometry: The M10 × 1 body is 40 mm long with a 2 mm unthreaded section at the sensing end.
- Ingress protection: The sensor tip and integral cable carry an IP68 protection rating when correctly installed.
- Conditioner: Use an IQS900 configured for the required 2 mm or 4 mm range and voltage or current output.
- Frequency response: The complete TQ902, EA902 and IQS900 chain is specified from DC to 20 kHz at the -3 dB point.
- Extension option: EA902 is the compatible extension-cable family when additional electrical length is required.
- Interchangeability: Components within the documented chain are designed to be interchangeable without pair calibration.
- Static position: Set the cold gap from the IQS900 output so expected shaft movement remains inside the selected linear range.
- Target material: Use the specified ferromagnetic target or assess the scale-factor change for another alloy.
- Cable support: Restrain the 5 m integral lead against abrasion, sharp bends and movement at the probe body.
- Connector seating: Fully engage the self-locking connector and keep its contacts clean and dry.
- Radial vibration: Measure shaft motion relative to the bearing or casing on rotating machinery.
- Axial position: Observe thrust movement with the probe facing an appropriate collar or shaft target.
- Spectral analysis: Use the IQS900 dynamic output for waveform and frequency-domain assessment.
- Protection channels: Provide a validated proximity input for machinery alarms, trips and condition monitoring.