Features:
- Standard-mount sensor: The 8.2 mm sensing tip and 42 mm M10 × 1 body fit compact machinery measurement points.
- Protected ten-metre lead: A 10 m integral cable with 9.8 m flexible stainless-steel hose protects the long machine-side route.
- Industrial sensing assembly: The sensor tip and integral cable are rated IP68, with documented operation from -40 to +180 degrees C.
Routing decision: Support the hose, preserve bend radius and keep the final unprotected section clear of abrasion.
Range decision: Pair the probe with the 2 mm or 4 mm IQS900 range required by the machine movement.
Signal decision: Set the static gap before using the conditioned output for protection or condition monitoring.
Apter Power supports Vibro-Meter TQ902-011 111-902-000-011 A1-B1-C42-D2-E10000-F2-G9800-H10 with technical documentation, quotations and configuration review.
Vibro-Meter TQ902-011 111-902-000-011 A1-B1-C42-D2-E10000-F2-G9800-H10 Proximity Transducer Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Mounting style: TQ902 is the standard-mount sensor in the TQ9x2 proximity family.
- Sensing body: The 42 mm M10 × 1 body has an 8.2 mm tip and a 2 mm unthreaded section.
- Measurement range: The sensor supports a 2 mm or 4 mm range when paired with the corresponding IQS900 option.
- Ingress protection: The sensing tip and integral cable are rated IP68 when correctly installed.
- Integral cable: The configured 10 m lead is part of the proximity measurement chain.
- Protective hose: A 9.8 m flexible stainless-steel hose with FEP covering shields most of the cable route.
- Mechanical support: Carry the hose weight independently and avoid kinks or crushing at brackets and entries.
- Self-locking connection: Keep the sensor connector clean, dry and fully engaged at the IQS900 interface.
- Frequency response: The complete TQ902, EA902 and IQS900 chain is specified from DC to 20 kHz at the -3 dB point.
- Dynamic output: Use the conditioned waveform for spectral analysis and advanced condition monitoring.
- Chain diagnostics: An IQS900 diagnostic option can report the health of the installed measurement chain remotely.
- Interchangeability: Documented chain components can be exchanged without pair calibration when range and ordering options agree.
- Remote monitoring points: Reach an IQS900 located away from the bearing or machine casing with a protected 10 m route.
- Shaft vibration: Measure dynamic radial movement without contacting the rotating surface.
- Thrust position: Track axial displacement where the probe faces a suitable target.
- Protection systems: Feed a validated dynamic signal to machinery-protection and advanced condition-monitoring functions.